FMP-REMOTE/LIFT

close X  

TV LIFT REMOTE CONTROL. THIS IS A REMOTE CONTROL SUPPLIED WITH EVER TV LIFT. MUST BE PROGRAMED TO EACH LIFT AS LISTED BELOW.

TV Lift Remote Setup
If Your TV lift remote does not work then refer to the
following steps:
1. Locate the manual control box. This is where the TV lift’s on/off switch &
manual motion switch are located. Look on the left side of the box where you
will see a series of numbers. The numbers with the circles filled in below
then represent the the lifts’s preset code. Write Down these numbers
because they will be used to sync the TV lift with the remote control
2. locate the TV lift”s remote (included). Turn the remote over and you will
see a series of numbers with filled in circles below them which represents
the preset code for the remote.
3. Compare the preset numbers from the Tv lift and the Remote. If they DO
match call Furnlite customer service. If the numbers DO NOT match continue
to STEP B.
STEP B
1. Place the remote face down with the writing upside down. Two screws
should be at the top and one centered at the bottom.***CAUTION*** This
will prevent the remote's internal parts from shifting while the remote is being
open to change the preset codes.
2. Locate a small slotted or phillips head screwdriver (not included).
3. Remove the 3 screws
4. Lift the back cover off . Keep the screws and cover together for reassembly.
5. Carefully LIFT THE BOTTOM ONLY of the circuit board up to reveal the
micro switches located above the battery. ***CAUTION*** be sure NOT
to remove the circuit board when lifting. This will cause several problems for
reassembly.
6.You will see a series of numbers and micro switches. The switches closest
to the number or in the DOWN position represents the current preset code.
7. Using the small screw driver or a pencil, push ALL the switches to the UP
position or away from the numbers to clear the current preset code.
8. Locate the code number you wrote down from the TV lift.
9. Push only the micro switches Down towards the number that corresponds
with the code number from the TV lift.
10. Push the circuit board back to its original position. The circuit board
should be flat within the box.
11. Place the back cover on the remote and screw it into place. Be sure not
to overtighten the screws.
12. The remote should work. Call Furnlite customer service if problems still
exist